Setting For Rear View Camera - Pioneer AVIC-F20BT Operation Manual

Chapter
27 Customising preferences
3 Insert an SD memory card into the SD
card slot.
= For details of the operation, refer to Insert-
ing and ejecting an SD memory card on
page 15.
Display the "System Settings" screen.
4
= For details, refer to Displaying the "System
Settings" screen on page 136.
5 Touch [Splash Screen].
The "Select Splash Screen" screen appears.
6 Touch [Select from SD].
The "Select Splash Screen" screen appears.
7 Touch the image to use as the splash
screen from the list.
The image is displayed on the screen.
8 Touch [OK].
The image is set as the splash screen, and the
"System Settings" screen returns.
p Images imported from the SD memory card
are added to the list on "Select Splash
Screen".

Setting for rear view camera

The following two functions are available. The
rear view camera feature requires a separately
sold rear view camera (e.g. ND-BC4). (For de-
tails, consult your dealer.)
Rear view camera
The navigation system features a function that
automatically switches to the full-screen
image of the rear view camera installed on
your vehicle. When the gear stick is in the RE-
VERSE (R) position, the screen automatically
switches to full-screen rear view camera
image.
Camera for Rear view mode
"Rear View" can be displayed at all times (e.g.
when monitoring an attached trailer, etc.) as a
split screen where map information is partially
displayed. Please be aware that with this set-
ting, camera image is not resized to fit, and
140
Engb
that a portion of what is seen by the camera is
not viewable.
= For details, refer to Setting for rear view
camera on this page.
CAUTION
Pioneer recommends the use of a camera which
outputs mirror reversed images, otherwise the
screen image may appear reversed.
p Immediately verify whether the display
changes to a rear view camera image when
the gearstick is moved to REVERSE (R)
from another position.
p When the screen changes to full-screen
rear view camera image during normal
driving, switch to the opposite setting in
"Polarity".
Display the "System Settings" screen.
1
= For details, refer to Displaying the "System
Settings" screen on page 136.
2 Touch [Back Camera].
The "Back Camera Settings" screen appears.
3 Touch [Camera] change the setting to
"On".
p You can only switch to "Rear View" if this
setting is "On".
4 Touch [Battery] or [GND] next to
"Polarity" to select the appropriate polarity
setting.
! Battery: When the polarity of the con-
nected lead is positive while the gearstick is
in the REVERSE (R) position
! GND: When the polarity of the connected
lead is negative while the gearstick is in the
REVERSE (R) position