Connecting Your Phone To The Computer Network; Connecting Your Phone To The Wired Network; Connecting Your Phone To The Wireless Network - Cisco SPA525G User Manual

Installing Your Phone

Connecting Your Phone to the Computer Network

Connecting Your Phone to the Computer Network

STEP 1
STEP 2
NOTE
Cisco Small Business Pro IP Phone SPA525G (SIP) User Guide
If you are using Power over Ethernet (PoE) to power the phone, the phone will
receive power when you connect an Ethernet cable from the phone's WAN port to
a switch in your network that provides PoE. See the
Wired Network" section on page

Connecting Your Phone to the Wired Network

You connect your phone to the local network by using an Ethernet cable:
Plug the Ethernet cable into the back of the base station into the slot marked "SW."
This port is labeled #4 on
Plug the other end of the Ethernet cable into the appropriate device on your
network, such as a network switch.

Connecting Your Phone to the Wireless Network

The PC port is not supported in wireless operation. The PC port is only supported
in a wired operation.
33.
Figure 1 on page 27.
NOTE: The SPA525G provides a second
Ethernet port. You can connect a PC to this port
to provide network access to the PC. This port
is labeled #3 in the Cisco SPA525G IP Phone
Connections graphic.
when the phone is connected to the network
via the built-in Wireless-G client.
"Connecting Your Phone to the
This port cannot be used
2
33