Sunbeam EM3820 Instruction Booklet page 17

Functions of your Café Espresso
• After each use of the espresso machine for
best results when making consecutive cups
of espresso we recommend that you flush a
small amount of water through the machine
with the group handle already removed
from the brewing head. Simply turn the
operating dial to the espresso setting and
allow the water to run through until you
have a consistent flow of water. This will
wash out any old or used coffee grinds
stuck to the underside of the brewing head
and also help ensure the correct water
temperature for your next shot of espresso.
Note: Do not leave the filter handle locked
in position for extended periods, or when
machine is not in use. This shortens the
life of the brew head rubber seal.
2. STEAM FUNCTION
The steam function can be used for texturing/
frothing milk.
Important: There is a risk of scalding when
the steam nozzle is in use. Hot water or
hot steam can cause scalding. Only use the
steam wand when it is immersed in the milk.
• Fill the water reservoir (1) (2) (3) (4) (5)
with cold water and start the unit (6).
• Position the steam wand so that the tip is
over the drip tray.
• Turn the dial to the steam (
(21). Some water will come out of the
steam wand. Once steam starts to come
out turn the dial to the off ( ) position
(26).
• Swing the steam nozzle to the side of the
machine (22).
• Pour cold milk into a stainless steel jug to
no more than full.
1 /
3
II (continued)
®
• Hold the jug under the steam wand so that
• Angle jug so the steam wand is resting on
• Move the jug so that the steam wand is
in the centre, this will create a whirlpool
motion to the milk. As the steam heats the
milk, the milk will begin to rise. Follow
the level of the milk by lowering the jug,
always keeping the tip of the steam nozzle
just below the surface (25).
• When milk is at temperature close the
steam by turning the dial back to the off
) position
Tip: For best results we recommend using
refrigerated milk and a stainless steel jug
that is well chilled. Be sure not to rinse the
jug with warm water before use.
the nozzle opening is completely immersed
in the milk. Turn the operating dial to the
( ) setting to activate the steam and
commence texturing the milk (23).
Tip: For instructions on how to froth/
texture milk refer to section 'Easy steps for
texturing milk'.
the spout of the jug and position the tip of
the steam wand just below the surface of
the milk (24).
Note: The nozzle must not touch the
bottom of the jug to ensure that the steam
release is not obstructed.
( ) position (26).
Note: Do not boil the milk.
15