Cleaning The Mouse; Optical Mouse - Lenovo ThinkCentre 3025 User Manual

Creating a diagnostic disc
This section provides instructions on how to create a diagnostic disc.
To create a diagnostic disc, do the following:
1. Download a self-starting bootable CD/DVD image (known as an ISO image) of
2. Use any CD/DVD burning software to create a diagnostic disc with the ISO
Running the diagnostic program from a diagnostic disc
This section provides instructions on how to run the diagnostic program from a
diagnostic disc that you created.
To run the diagnostic program from a diagnostic disc that you created, do the
following:
1. Make sure the optical drive you want to use is set as the first boot device in the
2. Make sure the computer is turned on and then insert the disc into the optical
3. Follow the instructions on the screen to select the diagnostic test you want to
4. Remove the diagnostic disc from the optical drive when you complete the

Cleaning the mouse

This section provides instructions on how to clean an optical or non-optical mouse.

Optical mouse

An optical mouse uses a light-emitting diode (LED) and an optical sensor to
navigate the pointer. If the pointer on the screen does not move smoothly with the
optical mouse, you might need to clean the mouse.
To clean the optical mouse, do the following:
1. Turn off your computer.
2. Disconnect the mouse cable from the computer.
3. Turn the mouse upside down to look at the lens.
4. Check the surface on which you are using the mouse. If you have a very
5. Reconnect the mouse cable to the computer.
52
User Guide
the diagnostic program from:
http://www.lenovo.com/support
image.
startup device sequence. See "Selecting a startup device" on page 43.
drive. The diagnostic program opens.
Note: You can insert the disc into the optical drive when you are setting the
startup device sequence. However, if you insert the disc into the optical
drive when you have already entered the operating system, you need to
restart the computer to access the diagnostic program.
run.
Note: For additional help, press the F1 key.
diagnostic process.
a. If there is a smudge on the lens, gently clean the area with a plain
cotton-tipped swab.
b. If there is debris in the lens, gently blow the debris away from the area.
intricate picture or pattern beneath the mouse it may be difficult for the digital
signal processor (DSP) to determine changes in the mouse position.