Installing Or Replacing A Memory Module - Lenovo ThinkCentre 3025 User Manual

3. Remove the front bezel by releasing the two plastic tabs and pivoting the front
Figure 6. Removing the front bezel
4. To reinstall the front bezel, align the plastic tabs on the bottom of the bezel
5. Go to "Completing the parts replacement" on page 29.

Installing or replacing a memory module

This section provides instructions on how to install or replace a memory module.
Your computer has two slots for installing or replacing DDR3 SODIMMs (small
outline dual inline memory modules) that provide up to a maximum of 4 GB
system memory. When installing or replacing a memory module, use 1 GB or 2 GB
DDR3 SODIMMs in any combination up to a maximum of 4 GB.
To install or replace a memory module, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Open the computer cover. See "Opening the computer cover" on page 14.
3. Locate the memory slots. See "Locating parts on the system board" on page 11.
16
User Guide
bezel outward.
with the corresponding holes in the chassis, and then pivot the front bezel
inward until it snaps into position.
Attention
Do not open your computer or attempt any repair before reading and
understanding the "Important safety information" in the ThinkCentre Safety
and Warranty Guide that came with your computer. To obtain a copy of the
ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support