Troubleshooting Tips; Before You Call For Service - GE 175D1807P396 Owner's Manual

Before you call for service...

Troubleshooting Tips

Save time and money! Review the charts on the following pages, or
visit GEAppliances.com. You may not need to call for service.
PERFECTEMP/AUTOTEMP
PerfecTemp or AutoTemp
wash temperature
is incorrect
(Review PerfecTemp
and AutoTemp in the
"About washer
features" section)
WATER
Too many suds
Water leaks
Water temperature
is incorrect
Water pumped out before
cycle is complete
Water won't drain
Washer pauses in cycle
12
Possible Causes
The washer is in a cold rinse cycle • This normal. The PerfecTemp and AutoTemp features
All the water in your household
water heater has been used
Possible Causes
Type of detergent
Very soft water
Too much detergent
Fill hoses or drain hose is
improperly connected
Household drain may
be clogged
Constant water pressure
to the fill hoses at the
water source
Using too much detergent
in washer
Control is not set properly
Water supply is turned off
or improperly connected
Water valve screens are
stopped up
House water heater is
not set properly
Lid lifted or cycle was put in
pause for over 24 hours
Drain hose is kinked or
improperly connected
The HANDWASH or CASUALS
cycle was chosen
What To Do
are designed not to activate during a cold rinse cycle
to improve the energy efficiency of your washer.
• Wait until the water in the water heater is heated to the
correct temperature.
What To Do
• Switch to a lower sudsing detergent brand and follow
instructions on package.
• Try less detergent.
• Measure your detergent carefully. Use less soap if you
have soft water, a smaller load, or a lightly soiled load.
• Make sure hose connections are tight at faucets and
rubber washers are installed. Make sure end of drain
hose is correctly inserted in and secured to drain facility.
• Check household plumbing. You may need to call
a plumber.
• Tighten hoses at the faucets and turn the water off after
each use.
• Check condition of the fill hoses; they should be
replaced every 5 years.
• Use less detergent. Use less soap if you have soft water,
a smaller load, or a lightly soiled load.
• Check water temperature control and adjust.
• Turn both hot and cold faucets fully on and make sure
hoses are connected to correct faucets.
• Turn off the water source and remove the water
connection hoses from the upper back of the washer.
Use a brush or toothpick to clean the screens in the
machine. Reconnect the hoses and turn the water back on.
• Make sure house water heater is delivering water
at 120°F–140°F(48°C–60°C).
• Reset cycle.
• Straighten drain hose and make sure washer is not
sitting on it.
• Top of drain outlet should be less than 8 ft (2.5 m)
above floor.
• This is normal. The washer alternates between agitate
and soak during the HANDWASH and CASUALS cycles to
get your clothes cleaner with less wear.