Care And Cleaning; Light Bulbs; Metal Grease Filter - GE Monogram ZV1050 Owner's Manual

Before servicing or cleaning unit, switch power
For your
off at service panel and lock the service
safety
disconnecting means to prevent power from
being switched on accidentally. When the
service disconnecting means cannot be locked,
Pour votre
securely fasten a prominent warning device,
securité
such as a tag, to the service panel.
Metal
Clean the grease filter after 30 hours of "on" time.
A red signal light will alert you when 30 hours
grease
has passed.
filter
Remove the grease filters and wash them
either by hand or in the dishwasher using
Clean
non-abrasive soap.
filter
To clean, swish the filters in hot soapy water
light
or wash them in the dishwasher. Do not use
abrasive cleansers.
Replace the filters and make sure that they are
correctly seated in the filter channels. Adjust as
necessary until the red signal light stops blinking.
Do not use a steel wool pad; it will scratch
Hood
the surface.
surfaces
To clean the stainless steel surface, use warm
sudsy water, a stainless steel cleaner such as Kleen
King
Always scrub in the direction of the grain. Rinse
thoroughly with a sponge or cloth and clean
water. Dry with a soft, clean cloth.

Light bulbs

To change the light bulbs:
1. Remove the trim ring by turning it
2. Grasp the bulb on the edges and
3. Replace with the same size bulb.
® , or an all-purpose liquid or spray cleaner.
counterclockwise.
pull it straight out.
These 12 volt, 20 watt halogen bulbs
are available at specialty lighting stores.
Ask for GE bulb or equivalent:
Q20MR16/C/CG40–BAB.

Care and Cleaning

Stainless Steel Hood
Avant de réparer ou de nettoyer votre appareil,
débranchez le courant au niveau du panneau
de service et verrouillez les mécanismes de
débranchement de service pour éviter tout
branchement accidentel au courant. Si vous
ne pouvez pas verrouiller les mécanismes
de débranchement de service, attachez
soigneusement un avertissement bien visible,
comme une étiquette, au panneau de service.
NOTE: To remove filters,
push them back and
down using the knob.
Front
For proper operation, make
sure the filters are securely
seated into the channels.
After cleaning, use a stainless steel polish, such as
Stainless Steel Magic
Stainless Steel Cleaner
®
Metal Polish . Follow the product instructions
for cleaning the stainless steel surface.
On some models, the lights
are located on the sides,
on the underside of the hood.
® , Revere Copper and
® or Wenol All Purpose
On some models, the lights are
located on the front and back,
on the underside of the hood.
7