Battery Voltage Light; Moving Machine By Hand - Husqvarna RZ46i Operator's Manual

Battery Voltage Light

A battery voltage light can indicate that voltage is
below the normal operating power.
If the battery is low when a start attempt is made,
the battery indicator button will light up. This is an
indication the battery should be charged. It will not
prevent additional start attempts as long as remaining
charge is capable of cranking the engine. The button
can also indicate a charge system failure if it lights up
during operation.
Checking Battery Charge System
When unit is in ready mode (blinking green), press
and hold the battery button for three seconds. The
S/S button indicator will show red (battery charge level
is low), multi-colored (battery charge is marginal) or
green (battery level is good) until the battery button
is pressed again or is allowed to reset after ten
seconds.

Moving Machine By Hand

When pushing or pulling the mower, engage the
EZT bypass linkages. The EZT bypass linkages are
located on the rear of the frame, below the rear engine
guard.
1. Raise the deck into the highest cutting position.
2. Engage the park brake.
3. Pull the EZT bypass linkages up and out of the
keyhole slots. Release the levers with the head
outside the frame and held in the bypass position.
4. To reengage the EZT's to drive, reverse the above
procedure.
Load the machine into truck or trailer by driving slowly
up the ramps. DO NOT LIFT! The machine is not
intended to be lifted by hand.
WARNING!
Bypass linkages are located close to the
muffler. To prevent burns, the engine
should be shut off and allowed to cool
before the bypass linkage levers are
handled.
WARNING!
Use extreme caution when loading the
machine into a truck or trailer using
ramps. There is the possibility of serious
injury or death if the machine falls off the
ramps.
OPERATION
Battery voltage light
Left side bypass linkage, EZT engaged
Left side bypass linkage, EZT locked in the bypass position
8058-239
8058-032
8058-033
37