ZyXEL Communications G-220 v2 User Manual page 63

Table 12 Station Mode: Profile: Add a New Profile (continued)
LABEL
Network Type
Next
Exit
Scan Info
,
,
or
SSID
Scan
Select
• If you select the Infrastructure network type in the previous screen, skip to the next step.
If you select the Ad-Hoc network type in the previous screen, a screen displays as
follows. Select a channel number and wireless LAN mode and click Next to continue.
Note: To associate to an ad-hoc network, you must use the same channel as the peer
computer.
Note: At the time of writing the Ad-hoc channel and wireless mode select is not
available on Windows Vista.
Chapter 4 Wireless Station Mode Configuration
DESCRIPTION
Select Infrastructure to associate to an AP. Select Ad-Hoc to associate to a peer
computer.
Click Next to go to the next screen.
Click Exit to go back to the previous screen without saving.
This table displays the information of the available wireless networks within the
transmission range.
denotes that the wireless device is in infrastructure mode and the wireless
security is activated.
denotes that the wireless device is in infrastructure mode but the wireless
security is deactivated.
denotes that the wireless device is in Ad-Hoc mode and the wireless
security is activated.
denotes that the wireless device is in Ad-Hoc mode but the wireless security
is deactivated.
This field displays the SSID (Service Set IDentifier) of each AP or peer device.
Click Scan to search for available wireless devices within transmission range.
Select an available wireless device in the table and click Select to add it to this
profile.
Whenever you activate this profile, the G-220 v2 associates to the selected
wireless network only.
ZyXEL G-220 v2 User's Guide
63