McAfee IIP-S03K-NA-100I - IntruShield 3000 Sensor Appliance Product Manual page 27

McAfee® IntruShield® IPS 4.1
IntruShield Sensor 3000 Product Guide
To connect a copper SFP
1
2
3
4
5
6
Figure 7: Connecting Copper SFP
7
8
9
10
11
12
Note:
disabled and enabled to restore the restore the configuration settings.
Note 2:
see
Remove the SFP module from its protective packaging.
Ensure the SFP module is the correct model for your network.
Locate the label on the SFP module and turn the module so that its label is on
top and the alignment groove is down.
Grip the sides of the module with your thumb and fore finger and insert SFP
module into the module socket.
SFP modules are keyed to prevent incorrect insertion.
Insert the copper SFP sensor Monitoring ports 1A/B, 2A/2B, 3A/3B, 4A/4B,
5A/5B, or 6A/6B. Slide the module until you hear a click indicating that it is
properly inserted into the slot.
Physical installation of the copper SFP has to be done to use this functionality.
Once you have plugged in the copper SFP, you can change the speed and other
configurations in the IntruShield Security Manager (ISM).
Lock the SFP module by pushing the bail clasp up into place.
Connect the network cable in the port.
Sensor > Sensors > Configure ports
In ISM, go to
Select the port where the SFP has been connected.
Change the speed and port settings to 10/100/10-auto/100-auto.
Check the LED turns green on the sensor.
Click OK.
If the SFP has been pulled and put back into the ports, the port has to be
For more information on configuring monitoring port settings from ISM,
Senor Configuration Guide—using ISM
Setting up the I-3000 sensor prior to configuration
.
.
19
Installing SFP modules