Enabling Dhcp - D-Link DFL-260E User Manual

3.4.2. Ethernet Interfaces
UserAuthGroups:
NoDefinedCredentials:
To show the current interface assigned to the gateway wan_gw:
gw-world:/> show Address IP4Address InterfaceAddresses/wan_gw
---------------------
UserAuthGroups:
NoDefinedCredentials:
By using the tab key at the end of a line, tab completion can be used to complete the command:
gw-world:/> show Address IP4Address InterfaceAddresses/wan_<tab>
[<Category>] [<Type> [<Identifier>]]:
InterfaceAddresses/wan_br
InterfaceAddresses/wan_dns1
InterfaceAddresses/wan_dns2
Here, tab completion is used again at the end of the command line:
gw-world:/> set Address IP4Address<tab>
[<Category>] <Type> [<Identifier>]:
dnsserver1_ip
InterfaceAddresses/aux_ip
InterfaceAddresses/aux_net InterfaceAddresses/wan_dns2
InterfaceAddresses/dmz_ip
InterfaceAddresses/dmz_net InterfaceAddresses/wan_ip
InterfaceAddresses/lan_ip
InterfaceAddresses/lan_net Server
Setting Interface Addresses
The CLI can be used to set the address of the interface:
gw-world:/> set Address IP4Address
Modified IP4Address InterfaceAddresses/wan_ip.

Enabling DHCP

The CLI can be used to enable DHCP on the interface:
gw-world:/> set Interface Ethernet wan DHCPEnabled=yes
Modified Ethernet wan.
<empty>
No
Comments: Network on interface wan
Property Value
---------------------------------
Name: wan_gw
Address: 0.0.0.0
<empty>
No
Comments: Default gateway for interface wan
InterfaceAddresses/wan_br timesyncsrv1_ip
InterfaceAddresses/wan_dns1
InterfaceAddresses/wan_gw
InterfaceAddresses/wan_net
InterfaceAddresses/wan_ip
Address=172.16.5.1
113
InterfaceAddresses/wan_gw
InterfaceAddresses/wan_ip
InterfaceAddresses/wan_net
Chapter 3. Fundamentals