Connection To External Equipment - Behringer EUROGRAND EG2280USB User Manual

20
EUROGRAND EG8280USB/EG2280USB User Manual
• Soft pedal
You can save the following settings for this group of functions:
•
Soft pedal function (see chapter 5.5.8)
•
Soft pedal intensity (see chapter 5.6.2)
Function: E8.4
Value:
On, Off
Description:
Off: Save function for soft pedal settings is disabled (default setting)
On: Save function for soft pedal settings is enabled
5.6.6 Restoring the factory default settings
Use the following procedure to recall the factory default settings.
◊
Tip: All saved parameters as well as the music sequencer data will be
lost during either one of the following procedures.
1) Use the POWER switch to switch the instrument off (if not already done).
2) Play and hold down the top C key on the keyboard, then switch the
EG2280USB/EG8280USB back on.
+
An alternative procedure is described below:
1) Use the POWER switch to switch the instrument off (if not already done).
2) Press and hold down the TRACK 1 and TRACK 2 buttons, then switch the
EG2280USB/EG8280USB back on.
+
3) Let go of the TRACK buttons after about 5 seconds.

6. Connection to External Equipment

The EG2280USB/EG8280USB provides a variety of connectors for connecting the
instrument to external devices.
! !
Caution
◊
Be sure that all devices are switched off before you make
any connection.
◊
NEVER connect the LINE IN connectors of the EG2280USB/EG8280USB
to its LINE OUT connectors. This will cause a feedback loop producing
high volume levels which could damage both the instrument and
your hearing!
6.1 Connecting external sound sources
The EG2280USB/EG8280USB is equipped with a stereo LINE IN connector for
connecting external sound sources to your digital piano. These signals are
reproduced through the internal loudspeakers and connected headphones.
If you wish to practice with musical accompaniment, you can use this input to
connect a CD player or drum computer. In the same way, you could connect an
external synthesizer or sound module and use its sound generator with your
instrument. An additional MIDI connection enables you to play an external sound
generator from the keyboard of the EG2280USB/EG8280USB (see chapter 6.3.1).
The keyboard also has a MIC input for the connection of dynamic or condenser
microphones, and an AUX IN jack for sound sources that use 1/8" plugs.
6.1.1 LINE IN jacks
The LINE IN jacks can be used to connect external sound sources such as
CD players, DVD players, or external sound modules that are being controlled by
the EG2280USB/EG8280USB's MIDI function (see fig. 6.3). The following diagram
shows a wiring example comprising the EG2280USB/EG8280USB and a CD player.
You need one or two cables fitted with RCA plugs (see chapter 9.1.3). As an
alternative, you can also use a ¼" cable with an appropriate adapter plug.
CD Player
Digital Piano
Fig. 6.1: Connecting external signal sources
1) Connect the outputs of the CD player to the LINE IN jacks of the
EG2280USB/EG8280USB.
Microphone MP3 Player
MIC IN
LINE IN AUX IN