Foxconn Q57M Series User Manual page 23

front Panel Connector : fP1
This motherboard includes one connector for connecting
the front panel switch and LED Indicators.
Hard Disk leD Connector (HDD-leD)
Connect to the chassis front panel IDE indicator LED. It
indicates the active status of the hard disks. This 2-pin
connector is directional with +/- sign.
Reset Switch (ReSeT-SW)
Attach the connector to the Reset switch on the front
panel of the case; the system will restart when the
switch is pressed.
Power leD Connector (PWR-leD)
Connect to the power LED indicator on the front panel
of the chassis. The Power LED indicates the system's
status. When the system is in operation (S0 status),
the LED is on. When the system gets into sleep mode
(S1) , the LED is blinking; When the system is in S3/S4
sleep state or power off mode (S5), the LED is off. This
2-pin connector is directional with +/- sign.
Power Switch Connector (PWR-SW)
Connect to the power button on the front panel of the
chassis. Push this switch allows the system to be turned
on and off rather than using the power supply button.
fan Connectors : CPU_fAN, SYS_fAN1
There are two main fan headers on this motherboard.
The fan speed can be controlled and monitored in "PC
Health Status" section of the BIOS Setup. These fans
can be automatically turned off after the system enters
S3, S4 and S5 sleeping states.
CoM Connector : CoM1
This motherboard supports one serial RS232 COM port for
legacy compatibility. User must purchase another RS232
cable with a 9-pin D-sub connector at one end to connect
with the external RS232 device and another end with 10-
pin female connector to connect with COM1 connector in
the motherboard.
HDD-LED
RESET-SW
CPU_FAN/SYS_FAN1
16
16
1 2
+ +
PWR-LED
-
-
PWR-SW
EMPTY
NC
9 10
FP1
1 GND
POWER
SENSE
CONTROL
1 2
RLSD SIN
SOUT DTR
GND DSR
RTS CTS
RI EMPTY
9 10
COM1