LIGHT
Step 6
Press [r] [r].
This returns you to Step 3 above.
another user number to assign authority level. Repeat Steps 4 - 6
until you have assigned authority levels to all user numbers.
Step 7
Press the [#] key to exit the Assigning Authority Level Program.
OTHER KEYPAD FUNCTIONS
SETTING THE KEYPAD TONE
Step 1
Press [r]-[0]. Keypad is now in the "Adjust Tone" mode.
Step 2
Pressing the [1] key will make the keypad sounder go to higher
tones, pressing the [2] key will make the keypad sounder go to lower
tones.
Step 3
When the desired tone is reached, press the [#] key to set this tone
and exit from the "Adjust Tone" mode.
VIEW ALARM MEMORY
Step 1
Press [r]-[3].
displayed on the keypad.
Step 2
The ALARM MEMORY feature will flash those zones that created
alarms and will light steady those zones that were bypassed during
the last alarm.
AUTHORITY LEVELS IF LIGHT 8 IS OFF
1
Reserved
2
Arm Only
Arm Only After Closing Time
3
4
Master Arm/Disarm (can program other codes)
5
Arm/Disarm
6
Bypass Zones
7
Open / Close Reporting
If this light is on, this code is programmed as a
8
function code. Do not change! Press [#] - [#] to
exit.
The zone(s) that created the last alarm will be
(Note: Do not change if on.)
At this point you may enter
11