Table of Contents
Advertisement
Cisco TelePresence System Codec C90 and Profile 65" Dual using C90
Contents
The video input matrix
The video input matrix is found at the rear side of the codec
and illustrates the combinations in which the video inputs can
be connected.
About the matrix
Only one video input source from each row can be active at
any time. The basic setup connectors are marked in bold.
The numbers in the left column represents the Video Input
Sources 1–5. The main connectors, which are used in basic
setup, are marked in orange color.
The Comp. 5 and S-Video (YC) 5 inputs uses the same
physical connectors and can not be connected at the same
time.
Configuring the video inputs
Go to Advanced configuration (menu on screen) or open the
System Configuration page (web interface) to configure the
video inputs.
Navigate to
Video > Input > Source [1–5]
five video input sources.
•
Name: "" (enter a name, and save)
•
Connector: <HDMI/HDSDI/DVI/YC/Composite/YPbPr>
(each input source's value space is a subset of this)
•
Quality: <Motion/Sharpness>
Navigate to
Video > MainVideoSource
DefaultPresentationSouce
to set the main video source and
the default presentation source for the system. The values
<1..5> represents the corresponding video input source [1–5].
D14635.13 Profile C90 and Codec C90 Administrator Guide TC7.0, DECEMBER 2013.
Introduction
Web interface
Default configurations
•
Video Input Source 1 Name: "Main Camera"
•
Video Input Source 2 Name: "Secondary Camera"
•
Video Input Source 3 Name: "PC"
and configure the
•
Video Input Source 4 Name: "DVD"
•
Video Input Source 5 Name: "Document Camera"
•
Video Input Source 1 Connector: HDMI
•
Video Input Source 2 Connector: HDMI
•
Video Input Source 3 Connector: DVI
•
Video Input Source 4 Connector: HDMI
•
Video Input Source 5 Connector: DVI
and
Video >
•
Video Input Source 1 Quality: Motion
•
Video Input Source 2 Quality: Motion
•
Video Input Source 3 Quality: Sharpness
•
Video Input Source 4 Quality: Motion
•
Video Input Source 5 Quality: Sharpness
•
Video MainVideoSource: 1 (which is the main camera)
•
Video DefaultPresentationSource: 3 (which is the PC)
System settings
Video input matrix
Input Sources
Connector Name
1st Camera
HDMI 1
HD-SDI 1
1
2
2nd Camera
HDMI 2
HD-SDI 2
PC
HDMI 3
HD-SDI 3
3
4
HDMI 4
HD-SDI 4
5
DVI-I 5
Comp. 5
132
Setting passwords
YPrPb 1
YPrPb 2
DVI-I 3
Only one video input source from each
–
row can be active at any time.
YC 5
www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Appendices
Appendices
Advertisement
Table of Contents
