Brother P-Touch PT-H500LI Quick Setup Manual page 27

Electronic labeling system
Hide thumbs Also See for P-Touch PT-H500LI:
Table of Contents

Advertisement

3
Confirm that the hooks on the edge of the rear cover are inserted correctly, and then
reattach the cover.
If you cannot attach the rear cover, check to ensure the white lever is in the up
position. If not, lift the lever, and then attach the cover.
Removing the Rechargeable Li-ion Battery
Remove the battery cover and the rechargeable Li-ion battery, and then reattach the battery
cover.
 Charging the Rechargeable Li-ion Battery
The rechargeable Li-ion battery can be charged while it is inserted in the P-touch labeler.
Perform the following procedure to charge the rechargeable Li-ion battery.
• Before using the rechargeable Li-ion battery, use the following procedure to charge it.
• Up to 360 minutes is needed to fully charge a rechargeable Li-ion battery.
1
Make sure that the P-touch labeler is turned off. If the P-touch labeler is turned on,
press the
(Power) button to turn it off.
2
Make sure that the rechargeable Li-ion battery is installed in the P-touch labeler.
3
Use the AC adapter and AC power cord to connect the P-touch
labeler to an AC power outlet.
The LED next to the adapter connector turns on during
charging, it goes off when the rechargeable Li-ion battery is
fully charged. The battery level indicator on the display will fill
with three bars
Stopping Rechargeable Li-ion Battery Charging
To stop rechargeable Li-ion battery from charging, disconnect the AC adapter cord.
Tips on Using the Rechargeable Li-ion Battery
• Charge the rechargeable Li-ion battery before use. Do not use it before it is charged.
• The rechargeable Li-ion battery charging can take place in 41°F-95°F (5°C-35°C)
environments. Charge the rechargeable Li-ion battery in an environment in this
temperature range. If the surrounding temperature is out of this range, the
rechargeable Li-ion battery will not be charged, and the battery indicator will remain
lit.
• If the P-touch labeler is used when both the rechargeable Li-ion battery is installed
and the AC adapter is connected, the battery indicator may turn off and charging may
stop even if the rechargeable Li-ion battery has not been fully charged.
.
27
Power Supply

Advertisement

Table of Contents
loading

Table of Contents