Dram Timing Configuration - Foxconn A7GMX-K User Manual

DIMMs exits power down mode by asserting the corresponding clock enable signal when a
transaction is scheduled to any DIMM connected to the clock enable signal. There are two
CKE pins per DRAM channel. For each channel :
[Channel] CKE control. The DRAM channel is placed in power down when all chip selects
associated with the channel are idle.
[Chip Select] CKE control. A chip select or pair of chip selects is placed in power down
when no transactions are pending for the chip select(s).

DRAM Timing Configuration

CMOS Setup Utility - Copyright (C) 1985-2006, American Megatrends, Inc.
DRAM Timing Configuration
Memory Speed Mode
Memory Speed Adjust
DRAM Timing Mode
↑↓←→:Move Enter:Select
► Memory Speed Mode
This item is used to enable/disable provision of DRAM timing by SPD device. The Serial
Presence Detect (SPD) device is a small EEPROM chip, mounted on a DDR2 memory
module. It contains important information about the module's speed, size, addressing mode
and various other parameters, so that the motherboard memory controller (chipset) can better
access the memory device.
Select [Auto] for SPD enable mode.
Select [Limit], the DRAM speed will not exceed the specified value listed in the "Memory
Speed Adjust" item. If SPD value is faster than "Memory Speed Adjust" value, it will run at the
specified "Memory Speed Adjust" speed. Otherwise, SPD value is selected.
Select [Manual], then DRAM speed is manually selected according to the set value of
"Memory Speed Adjust".
► Memory Speed Adjust
This item will appear only when the "Memory Speed Mode" is set to [Limit] or [Manual].
The available settings are : [400MHz], [533MHz], [667MHz], [800MHz], [1066MHz].
[1066MHz] will appear only in AM2+ CPU.
► DRAM Timing Mode
When both DCTs (DRAM controller) are enabled in unganged mode, BIOS must initialize the
frequency of each DCT in order, you also can configure the timings manually.
Settings are : [Auto], [DCT 0], [DCT1], [Both].
[DCT 1] and [Both] will appear only in AM2+ CPU.
DRAM Timing Configuration
[Auto]
[Auto]
[Auto]
[Auto]
+/-/:Value F10:Save ESC:Exit
F9:Optimized Defaults
32
Help Item
Options
Auto
Limit
Manual
F1:General Help