Displaying The Firmware Version; Switching Between Two Connected Cell-Phones; Bluetooth Detail Setting - Kenwood KDC-U7056DAB Instructions Manual

Bluetooth settings

16-4. Displaying the firmware version

You can view the version of the firmware of this
unit.
1
Press [Ú].
"BT MODE" appears and enter the Bluetooth mode.
2
Select "Settings" > "Detailed Settings" > "BT
F/W Update" using [Control] knob.
For how to use [Control] knob, refer to <3-3. How
to select the item> (page 9).
The firmware version appears.
Exiting from the Bluetooth mode
Press [Ú].
How to update
• For how to update the firmware, access our web site.
www.kenwood.com/bt/information/
76
|
KDC-U7056DAB/ KDC-U7056BT/ KDC-U7056BTL
16-5. Switching between two
connected cell-phones
When two Bluetooth devices are connected, you
can assign the Bluetooth device to be used in
priority to the other Bluetooth device.
1
Press [Ú].
"BT MODE" appears and enter the Bluetooth mode.
2
Select "Device Priority" using [Control] knob.
For how to use [Control] knob, refer to <3-3. How
to select the item> (page 9).
3
Select a "Sub –###–" using [Control] knob.
"Main": Device used normally.
"Sub": Device used only for call reception.
4
Press [Control] knob.
Exiting from the Bluetooth mode
Press [Ú].

16-6. Bluetooth detail setting

You can configure the initial settings of this unit.
1
Press [Ú].
"BT MODE" appears and enter the Bluetooth mode.
2
Select "Settings" > "Detailed Settings" using
[Control] knob.
For how to use [Control] knob, refer to <3-3. How
to select the item> (page 9).
3
Select a Bluetooth detail setting item using
[Control] knob.
Display Description
"Auto Answer" Automatically answers a call after lapse of the
preset time interval.
"OFF": Does not answer the phone call
automatically.
"1SEC" – "8SEC" – "99SEC":
Automatically answers the phone call after lapse
of 1 – 99 seconds.
"Auto Reconnect" When set to "ON", starts re-pairing with the
registered Bluetooth device automatically when
it becomes unpaired.
"ON" / "OFF"
"Auto Pairing" When set to "ON", the Apple Auto Pairing
function is turned on to automatically register
the iPod touch or iPhone connected to this unit.
"ON" / "OFF"
"Bluetooth HF/Audio" Specifies the output speakers for hands-free
voice communication and Bluetooth audio
sound.
"Front" : Outputs sound from the front speakers.
"All" : Outputs sound from the front and rear
speakers.
"Call Beep" Sets whether to output a beep from the speaker
when a call comes in.
"ON" : Outputs a beep.
"OFF" : Does not output a beep.
"MIC Gain" Adjusts the sensitivity of the microphone for
telephone call or adjusts the voice of the caller.
"-20" – "0" – "+8"
"Echo Cancel Level" Sets the echo cancellation level.
"1" – "4" – "10"
(Colored text: Factory setting)
4
Select a setting using [Control] knob.
Returns to the previous item.
Exiting from the Bluetooth mode
Press [Ú].
77
|
English