Kenmore 795.7940 Series Use & Care Manual page 26

WATER FILTER
This system has been tested according to NSF/ANSI Standards 42 for the reduction of the substances listed
below. The concentration of the indicated substances in water entering the system was reduced to a concentration
less than or equal to the permissible limit for water leaving the system as specified in NSF/ANSI 42.
System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of
Chlorine Taste and Odor and Nominal Particulate Class III.
Capacity: 500 gal (1,892 L)
Substance
Nominal Particulate
Class I Particle size: ›0.5 to ‹1 um
Chlorine taste and
odor
Class III
Note that while the testing was performed under standard laboratory conditions, actual performance may vary.
Application Guidelines / Water Supply
Parameters
Service flow
Water pressure
Water temperature 33ºF - 100ºF (0.6ºC -
WARNING
To reduce the risk associated with ingestion
of contaminants due to use with water that is
microbiologically unsafe or of unknown
quality. Do not use with water that is
microbiologically unsafe or of unknown
quality without adequate disinfection before
or after the system.
Systems must be installed and operated in accordance
with manufacturer's recommended procedures and
guidelines.
USING YOUR REFRIGERATOR
Models Number ADQ72910907
Use with replacement cartridge ADQ72910907
Influent Challenge
Average
Concentration.
Influent
Units apply to
Concentration
each row
At least 10,000
24,333
particles/ml
1.9 2.0 mg/L ± 10%
0.5 gpm (1.89 lpm)
20 - 125 psi (138 - 862
kPa)
38ºC)
Performance Data Sheet
Avg. Product
Water
Concentration
915
0.07
To reduce the risk of property damage due to water
leakage:
• Read and follow the Use & Care guide instructions
before installation and use of this system.
• Install on COLD water lines only.
• Comply with all state and local plumbing codes.
• Install a pressure limiting device and water
hammer arrester for inlet water pressures
exceeding 80 psi (552 kPa). Refer to Uniform
• Plumbing Code, Sections 608.2 and 609.10.
• Never install or operate where inlet water pressure
may exceed 120 psi (827 kPa).
• Protect filter from freezing. Remove filter in
temperatures below 33° F (0.6° C).
• Replace cartridge at specified service interval.
Cartridge MUST be replaced at least every 6
months.
To purchase a replacement water filter, call 1-800-469-
4663 and ask for Part. No. ADQ72910907.
26
NSF % reduction req.
Average
or Max. permissible
%
product water
Reduction
concentration
96 ≥ 85%
96.4 ≥ 50%
CAUTION