Kenmore 795.7940 Series Use & Care Manual page 16

REFRIGERATOR INSTALLATION
Using a 13 / 32 '' socket wrench with a 2-Inch extension
and screwdriver, loosen the two bolts and one screw, and
remove the Bottom Hinge from right side of the housing.
Remove the Decorative Caps on the bottom of the
refrigerator housing. You will need these holes for the
Bottom Hinge.
Move the Bottom Hinge to the left side of the housing,
keeping the same orientation, and reattach with the two
bolts and one screw. The flat screw must be placed on the
exterior side of the hinge. Move the Decorative Bolt to the
hole on the lower right side of the housing.
Turn the refrigerator door upside down on a non-
scratching surface. Loosen the two screws to remove the
Bottom Hinge Pin Insert Bracket with the Hinge Pin Insert.
Hinge
Pin Bracket
Hinge Pin
Insert
Take out the Hinge Pin Insert and move the Bracket to the
other side of the door, keeping the same orientation.
Place the Hinge Pin Insert into the left side of the bracket.
Tighten the Hinge Pin Bracket to the door.
With a flat-head screwdriver, carefully pry off and
remove the cover over the screw holes on the left side of
refrigerator housing.
Remove the outer lower Decorative Screw from the
housing at the area between the freezer and refrigerator
doors. (You will need this hole for the Middle Hinge
Bracket.)
Flip the Middle Hinge Bracket, (flange will now be on
top) position it on left side of the refrigerator and re-
attach with two bolts and a Phillips screwdriver. Place the
refrigerator door down over the pin on the bottom hinge.
Place the washer between the refrigerator door and
middle hinge and re-attach Hinge Pin to Hinge Bracket
with a ¼" socket wrench.
NOTE: Bracket has been flipped, but Hinge Pin stays
in the same orientation with its hexagonal end facing
upward
.
16
Hinge
Pin Bracket
Hinge Pin Insert
Flange
Middle Hinge
Bracket