Controls And Features - GE Monogram ZIBI240 Owner's Manual

The temperature display shows the actual
Temperature
temperature of the bar refrigerator with
control
icemaker. The actual temperature may
vary slightly from the set temperature
based on factors such as door openings,
amount of food and room temperature.
To change the temperature setting, press
the WARMER or COLDER pads until you
reach the desired set temperature. After
5 seconds, the display will return to the
actual temperature.
After making adjustments, allow 12 to 24
hours for the bar refrigerator with icemaker
to reach the temperature you have set and
before making any further adjustments.
Child control
This child control lockout feature
prevents unwanted changes to your
lockout
temperature settings.
Unit
This pad stops cooling in the bar refrigerator
with icemaker, turns off the temperature
ON/OFF
controls and removes power to the light circuit.
NOTE: The icemaker is on a separate
on/off switch. To remove power from the
icemaker See Automatic Icemaker section.
Press this pad for a minimum of 3 seconds
to turn the bar refrigerator with icemaker
on or off, or unplug the unit for long
vacations or absences, or when cleaning
the unit or changing the light bulb.
Tempered glass shelves in the bar
Glass shelves
refrigerator with icemaker are removable
for easy cleaning or for storing larger items.
To remove a shelf, open the door
completely to avoid potential damage to
the gasket. Lift up on the back of the shelf
slightly. Tilt the shelf to one side at an
angle while pulling forward.
8
Appearance may vary
To remove, lift up on the back of the shelf

Controls and Features

NOTE: The icemaker temperature is not displayed.
Temperature Settings
Minimum: 34°F (1.1°C)
Maximum: 45°F (7.2°C)
After the desired temperature is set, the
temperature can be locked. To lock, press
both the + and – pads at the same time for
five seconds. To unlock, press both + and
– pads for five seconds.
To replace a shelf, open the door
completely to avoid potential damage to
the gasket. Tilt the shelf to one side at an
angle and slide toward the back wall,
placing one side onto the shelf support.
Place the other side onto the opposite shelf
support. Ensure rear locking tabs are
engaged. When installed properly, the shelf
will not slide forward when gently pulled.
Tilt the shelf at an angle while removing
or replacing
Bar Refrigerator with Icemaker
Place in slots when replacing the shelf