Privacy Masking (300 And 500I Series Only); Motion Detection With Region Of Interest (500I Series Only) (Preset Positions 90 Through 99) - Bosch VG4-200 User Manual

50 en | Advanced Features
7.4

Privacy Masking (300 and 500i Series Only)

Privacy Masking is used to block out a specific area of a scene from being viewed. Mask
choices have been expanded to include black, white, or blurred, and can be configured with
three, four, or five corners to cover more complex shapes.
NOTICE! Privacy Masking does not hinder AutoTrack from tracking an object.
i
–
–
7.5 Motion Detection with Region of Interest (500i Series Only)
(Preset positions 90 through 99)
With the 500i Series AutoDome, the motion detection software can be configured to create a
Region of Interest within multiple preset positions or scenes. It can take advantage of Virtual
Masking to ignore motion in predefined areas. Motion Detection can also be used as an Alarm
Rule input.
Preset positions 90 through 99 are reserved for programming motion detection scenes.
NOTICE! Motion Detection always takes precedence over AutoTrack object tracking.
i
To set up a scene with Motion Detection:
1.
2.
3.
4.
5.
NOTICE! Up to five (5) anchor points can be used to form the area which you want to detect
i
motion within. Motion Detection is not activated until the Preset scene is recalled. The Motion
Detection icon "M" appears in the upper left-hand corner of the display.
F.01U.133.267 | 6.0 (IP4) | 2009.06
To configure a Privacy Mask, open the Main menu, select Display Setup, and then select
Privacy Mask. Alternatively, enter the keyboard command ON-87-ENTER. To setup a
privacy mask, follow the on-screen menu instructions.
In Pelco Mode open the Pelco Main menu, open the Bosch menu, select the Display
Setup menu, and finally select Privacy Masking. To setup a privacy mask, follow the on-
screen menu instructions
Choose an unused Preset position from 90 to 99. For this example use Preset scene 95.
Enter the keyboard command SET-95-ENTER.
Select YES at the Apply Motion Detection? prompt. (If NO is selected, the Preset scene
does not activate Motion Detection.)
Select YES at the Apply Region of Interest? prompt. (If NO is selected, the entire scene is
used for Motion Detection.)
Follow the on-screen menu instructions to construct the shape of the screen area you
want to detect motion within.
User's Manual
VG4 AutoDome Modular Camera System
Bosch Security Systems, Inc.