Functions And Controls; Features And Controls; Control Functions - Snapper 150Z Operator's Manual

Ground Speed Levers - Ground Speed Levers -
DRIVE Positons START/PARK Positons
Parking Brake Lever - Parking Brake Lever -
ENGAGE Positon DISENGAGE Positon

Control Functions

The information below briefly describes the
function of individual controls. Starting,
stopping, driving, and mowing require the
combined use of several controls applied in
specific sequences. To learn what combination
and sequence of controls to use for various
tasks please read the entire section.
Ground Speed levers
These levers control the ground speed of the rider. The
left lever controls the left rear drive wheel and the right
lever controls the right rear drive wheel.
Pushing the levers out to the side, away from the
operator's lap (top inset, Figure 1), is the proper position
for starting the rider. Pulling the levers in across the
operator's lap puts the levers in DRIVE positions.
From DRIVE position, moving a lever forward increases
the FORWARD speed of the associated wheel. Pulling
back on a lever increases the REVERSE speed. The
further a lever is pushed, the faster the drive wheel will
turn.
See DRIVING PRACTICE for steering instructions.
Left
Ground Speed
Control Lever
Parking
Brake
Lever
Fuel Tank
Cap
Transmission
Release Levers
Move the parking brake lever (bottom inset, Figure 1) up
and across and into the locking notch to engage and lock
the parking brake. Move the parking brake lever across
and down to disengage the parking brake. The engine
will not start unless the parking brake is engaged.
Note: The parking brake must be disengaged before
operating the ground speed levers.
The engine speed control/choke controls the engine
speed and choke. Always set the engine speed to FAST
for driving and mowing. Move the engine speed
control back to SLOW to decrease engine speed.
Move the engine speed control/choke control to the
CHOKE position for starting a cold engine. A warm
engine may not require choking.

Features and Controls

OFF
Mower Blade
Switch
Ignition
Switch
Parking Brake lever
Engine Speed Control/Choke
Right
Ground Speed
Control Lever
Mower
Cutting
Height
Switch
Choke
Engine
Speed
(Fast)
Engine
Speed
(Slow)
RUN
START
Figure 1. Controls
13