Watching A Dvd Image; Connecting A Dvd Player; Displaying A Dvd Image - Pioneer PDP-434HDE Operating Instructions Manual

10 Enjoying through External Equipment

Watching a DVD image

Connecting a DVD player

Use the INPUT 3 terminal when connecting to a DVD
player and other audiovisual equipment.
• If a SCART cable has been connected to the INPUT 3
terminal with the i/o Link.A activated, input signals
(other than Component) are automatically identified
and displayed. If the i/o Link.A has been deactivated,
Video is always selected for signals other than RGB
because the system cannot identify among RGB, Y/C
(S-Video), and CVBS (Video) signals; for example,
receiving Y/C (S-Video) signals results in mono-
chrome display.
Media Receiver (rear view)
I N OUT
CONTROL
SERVICE ONLY
INPUT 1 INPUT 1
i / o link.A
SELECT
INPUT
2 3
INPUT 2 INPUT 2
SCART cable
(commercially available)

Displaying a DVD image

To watch a DVD image, press INPUT 3 on the remote
control unit or press INPUT on the Plasma Display to
select INPUT3.
50
En
INPUT 3
SUB WOOFER
OUTPUT COMPONENT VIDEO
Y P P
B R
MONITOR
OUTPUT
VIDEO R-AUDIO-L
INPUT 3 INPUT 3 S- VIDEO
AC INLET
BLACK
WHITE
SYSTEM CABLE
Component cable
(commercially available)
When using component cable,
select "COMPONENT" for "Input
Select" in the menu. See page 65.
At the same time connect a SCART
cable to input audio signals.
DVD player
• If DVD images do not come in clearly, you may need
to change the input signal type setting using the
menu. See pages 65 and 66.
• Refer to your DVD player operation manual for the
signal type.