MULTIQUIP Mikasa MVH-702DRSC Operation And Parts Manual page 22

BEFORE OPERATION
1. Familiarize yourself with the operating and control elements
of the machine and the working environment. This includes
obstacles in the working area, bearing capacity of the
ground and the necessary safety provisions.
2. Understand the geographical features and regulations of
the job site.
3. Inspect caution decals and replace missing/worn-out ones.
4. Check nuts and bolts and tighten if necessary. Loose threads
may cause damage to the machine when vibrating.
5. Make sure lifting hook, shock mounts and control parts are
all working properly. Do not start the machine if any failure
is noted.
6. Wipe off any dust from the receiving lamp of the machine.
Checking Engine Oil Level
CAUTION :
DO NOT overfill oil tank. This could cause
oil leaks and sluggish operation. Clean cap
and surrounding area before opening to
prevent dirt from entering tank.
1. Make sure that the machine is situated in a flat surface so
that level measurements will be accurate.
2. Open the front cover of the machine by moving the lever to
the "OPEN" position then slowly lifting the hook on the cover
(Figure 12).
Pull slowly to open
Figure 12. Opening the Front Cover
3. Pull out the dipstick from the oil tank (Figure 13). Check the
oil level and refill if necessary. For selection of proper grade
of diesel engine oil, refer to Table 3 in Troubleshooting
section.
PAGE 22 — MQ-MIKASA MVH-702DRSC COMPACTOR — PARTS & OPERATION MANUAL — REV. #1 (12/17/03)
Move to the OPEN
position
MVH-702DRSC — OPERATION
Figure 13. Oil and Fuel Tanks
CAUTION :
Lower grade or lower volume of engine oil can
cause engine burns. The built in sensor
continues to run for about 3 minutes after
sensing lack of oil. Make sure that oil level is
sufficient before starting operation
Checking Engine Oil Level
1. Unscrew the fuel tank cap. See Figure 13 for location.
2. Visually inspect the fuel level and refill if necessary.
DANGER :
Do not refill with fuel in poorly ventilated
environment. When refueling, make sure the
engine is shut down and that there is no
possibility of starting a fire.
CAUTION :
.
Wipe off fuel spills immediately when
overfilled.
Checking The Hydraulic System
1. Check the oil tank level gauge (Figure 14). Oil level should
be at the upper indication of the gauge.
2. Check the surroundings of the oil tank, hydraulic pump and
motor for oil leakage.
3. After inspection, close the front cover slowly.
DANGER :
Always keep hands and fingers away from
pinch points. Do not allow anyone to reach
in on dangerous sections of the machine to
avoid any accidents.
Oil Tank
Fuel
Tank