Replacing The Fuse - Yamaha VINO XC50Z Owner's Manual

Fuse, replacing<IXE>
The battery is located under the
footboard. Remove panel A to access
the battery. (See page 6-6.)
To charge the battery
Have a Yamaha dealer charge the bat-
tery as soon as possible if it seems to
have discharged. Keep in mind that the
battery tends to discharge more quickly
if the vehicle is equipped with optional
electrical accessories.
NOTICE
To charge a VRLA (Valve Regulated
Lead Acid) battery, a special (con-
stant-voltage) battery charger is re-
quired. Using a conventional battery
charger will damage the battery. If you
do not have access to a constant-volt-
age battery charger, have a Yamaha
dealer charge your battery.
To store the battery
1.If the vehicle will not be used for more
than one month, remove the bat-
tery, fully charge it, and then place
it in a cool, dry place. NOTICE:
When removing the battery, be
PERIODIC MAINTENANCE AND ADJUSTMENT
sure the key is turned to "OFF",
then disconnect the negative lead
before disconnecting the positive
lead.
[ECA16302]
2. If the battery will be stored for more
than two months, check it at least
once a month and fully charge it if
necessary.
3. Fully charge the battery before in-
stallation.
4. After installation, make sure that
ECA16520
the battery leads are properly con-
nected to the battery terminals.
NOTICE
Always keep the battery charged. Stor-
ing a discharged battery can cause
permanent battery damage.

Replacing the fuse

ZAUM00**
1. Fuse
ECA16530
The fuse holder is located beside the
battery. Remove panel A to access the
fuse. (See page 6-6.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to "OFF" and turn off
2. Remove the blown fuse, and then
6-21 6-57
1
all electrical circuits.
install a new fuse of the specified
amperage. WARNING! Do not use
a fuse of a higher amperage rat-
ing than recommended to avoid
causing extensive damage to the
EAU1722A
EAUT1241
1
2
3
4
5
6
7
8
9