How To Use - Shark Lift-Around NP319 series Owner's Manual

How to Use

Fig. 1
Fig. 4
ASSEMBLING THE LIFT-AROUND
1 Insert the end of the flexible hose into the
connector on the front of the Lift-Around™
Portable Vac. (fig. 1)
2 Insert the removable tool caddy onto the back
of the Portable Vac. (fig. 2) To remove the tool
caddy, hold the vacuum by the handle, pull out
slightly from the right side and then remove it from
the Portable Vac. (fig. 3)
3 Insert the crevice tool, dusting brush and
upholstery brush into the openings on the tool
caddy. (fig. 4)
4
Attach the shoulder strap onto the hooks on the
handle of the Portable Vac. (fig. 5)
5 Empty Dust Cup after cleaning and periodically
during cleaning when it appears full. (See
"Maintenance" section for instructions.)
8 TOLL FREE: 1-800-798-7398
NP319series_40_IB_ENG_120409_4.indd 8
Align arrows to attach tool caddy
Fig. 2
Power
Button
Fig. 5
PORTABLE VAC
™
Pull out to remove tool caddy
Fig. 3
FOR ADDED COMFORT OR FOR AN EXTENDED
REACH
6 Insert the telescopic tube to the flexible hose.
Push it in until it is secure. (fig. 6)
NOTE: All accessories may be used with the
flexible hose or the telescopic tube.
7
Attach the desired accessory to the end of the
flexible hose or telescopic tube by pushing it in
until it is tightly secured. (fig. 6)
8 While holding the Portable Vac by the handle,
press down on the power button to turn the
Portable Vac on and begin vacuuming. Press down
again to turn the vacuum off. (fig. 5)
Fig. 6
12-04-09 2:11 PM