Shark Lift-Around NP319 series Owner's Manual page 10

Maintenance - cont.
COMPONENT
Dust Cup
1
2 Pre-Motor Foam Filter
3 Pre-Motor Felt Filter
4
Post-Motor HEPA Filter
DO NOT operate the vacuum without ALL the filters in place.
DO NOT operate the vacuum with WET filters.
IMPORTANT: Loss of Suction may occur if foam
filter is not cleaned every month. Rinse and allow to air
dry completely. Tap loose dirt from foam filter as needed
in between washing. Foam filter may appear dirty after
use - this is normal.
Pre-Motor
Foam Filter
Felt Filter
CLEANING THE PRE-MOTOR FILTERS
1
Remove the dust cup.
2
Remove the pre-motor filters out from the top of
the motor base. (fig. 11)
3 Rinse the filters thoroughly in lukewarm water until
the water runs clear.
DO NOT put the filters in the washing machine or
dishwasher.
NOTE: The material in the filters will discolor
over time. This is NORMAL and will not affect the
performance of the filters.
4 Squeeze out excess water and let air-dry for at
least 24 hours before replacing. Do not use a hair
dryer or other heating methods to dry.
5
Place the felt filter in first, then the foam filter.
6 Replace the dust cup.
10 TOLL FREE: 1-800-798-7398
NP319series_40_IB_ENG_120409_4.indd 10
MAINTENANCE SCHEDULE
Empty each time you vacuum.
Rinse and air dry every month under normal use.
Rinse and air dry every month under normal use.
Clean once every 24 months under normal use.
Fig. 11
Post Motor
HEPA Filter
Fig. 12
CLEANING THE POST-MOTOR HEPA FILTER
1
Remove the tool caddy from the unit.
2 Remove the filter cover from the vacuum by pulling
up on the tab and pulling the cover away from the
vacuum. (fig. 12)
3
Take out the HEPA filter by pulling it straight out.
4
Turn the filter over so that the dirty side is on
the bottom and vigorously tap it clean against a
garbage can to remove any dust. (fig. 13)
5
Wash the filter under the tap using lukewarm
water with the dirty side face down until the water
runs clear. (fig. 14)
DO NOT put the filter in the washing machine or
dishwasher.
NOTE: The material in the filter will discolor over
time. This is NORMAL and will not affect the
performance of the filter.
6
Allow the filter to air dry for 24 hours. Do not use a
hair dryer or other heating methods to dry.
7 Once the HEPA filter is dry, replace it back into the
vacuum.
8
Replace the cover by inserting the two tabs into
the holes at the top and then swinging the cover
down until it clicks into place.
Fig. 13
Fig. 14
12-04-09 2:11 PM