Section Three; Component Access; Removing The Console - Whirlpool 27' Job Aid

Note : Potential floor damage. Slide dryer onto cardboard or hardboard before moving across
floor. Failure to do so may damage floor covering.

Removing the Console

1. Remove the two screws at the base of the console. (Fig.11)
2. Grab console on both sides. Pull console towards you, lifting the tabs up and out of the
console slots. Carefully flip console back to make repairs. Do not lean console against
wall. Console may mar or damage wall. If dryer is too close to wall, pull dryer forward
so console does not touch wall. (Fig. 12)
Electronic
Dryness
Control Timer

SECTION THREE

COMPONENT ACCESS

COMPONENT ACCESS
COMPONENT ACCESS
COMPONENT ACCESS COMPONENT ACCESS
CONSOLE CONTROL REPAIRS
! WARNING
Disconnect the electrical power before servicing any components.
Failure to do so can result in death or electrical shock.
Fig. 11
"Clean Touch"
Switch
Assembly
ELECTRIC SHOCK HAZARD
Push-to-Start
Buzzer
Switch
Fig. 13
13
Fig. 12