Starting The Pbx; System Initialisation Procedure - Panasonic KX-TDA100 Installation Manual

2.14 Starting the PBX

2.14.1 Starting the PBX
CAUTION
•
Before touching the System Initialise Switch, discharge static electricity by touching ground or wearing
an earthing strap.
•
Once you have started the PBX and if you unplug the PBX, do not perform the following procedures
to start the PBX again. Otherwise, your programmed data is cleared. To restart the PBX, refer
to "4.1.4 Using the Reset Button".
•
The power supply cord is used as the main disconnect device. Ensure that the AC outlet is located
near the equipment and is easily accessible.
•
Use only the AC power cord included with the PBX for the PSU.
Notice
The SD Memory Card must be inserted in the SD Memory Card slot of the MPR card before startup.
Note
The PBX will continue to be powered even if the power switch is turned "OFF".

System Initialisation Procedure

1.
Slide the System Initialise Switch to the "SYSTEM INITIALIZE" position.
RUN Indicator
Reset Button
System Initialise Switch
RESET
SYSTEM
INITIALIZE
NORMAL
2.14.1 Starting the PBX
Installation Manual 249