Setting The Rear Output And Subwoofer Controller; Switching The Sound Muting/Attenuation - Pioneer FH-P6050UB Operation Manual

Initial Settings
3 Press MULTI-CONTROL to turn dimmer
on.
# To turn dimmer off, press MULTI-CONTROL
again.
Setting the rear output and
subwoofer controller
This unit's rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (REAR SP :FULL) or subwoofer
(REAR SP :S/W) connection. If you switch the
rear output setting to REAR SP :S/W, you can
connect a rear speaker lead directly to a sub-
woofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (REAR SP :FULL). When rear
output is connected to full range speakers
(when REAR SP :FULL is selected), you can
connect other full range speakers
(PREOUT :REAR) or a subwoofer
(PREOUT :SUB W) to the RCA rear output.
1 Display the initial setting menu.
Refer to Adjusting initial settings on page 27.
2 Use MULTI-CONTROL to select
S/W CONTROL.
3 Press MULTI-CONTROL to switch the
rear output setting.
Pressing MULTI-CONTROL will switch be-
tween REAR SP :FULL (full-range speaker) and
REAR SP :S/W (subwoofer) and that status will
be displayed.
# When no subwoofer is connected to the rear
output, select REAR SP :FULL (full-range speak-
er).
# When a subwoofer is connected to the rear
output, select REAR SP :S/W (subwoofer).
# When the rear output setting is
REAR SP :S/W, you cannot operate the following
procedure.
4 Push MULTI-CONTROL left or right to
switch the subwoofer output or rear out-
put.
Pushing MULTI-CONTROL left or right will
switch between PREOUT :SUB W and
PREOUT :REAR and that status will be dis-
played.
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
25).
! If you change this setting, subwoofer output
in the audio menu return to the factory
settings.
Switching the sound
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
! The sound is muted or attenuated,
TEL MUTE or TEL ATT are displayed and
no audio adjustment is possible.
! Sound from this system returns to normal
when the muting or attenuation is can-
celed.
1 Display the initial setting menu.
Refer to Adjusting initial settings on page 27.
2 Use MULTI-CONTROL to select MUTE.
3 Press MULTI-CONTROL to switch the tel-
ephone muting/attenuation.
Pressing MULTI-CONTROL will switch be-
tween TEL ATT (attenuation) and TEL MUTE
(muting) and that status will be displayed.
Section
04
29
En