Important - Please Read And Follow; Tools You Will Need; Materials You Will Need - Viking Undercounter Dishwashers Installation Manual

IMPORTANT - PLEASE READ AND FOLLOW

•Before beginning - please read these instructions completely and carefully
•Do not remove permanently affixed labels, warnings, or rating plates from the dishwasher. This may void warranty.
•Please observe all national and local codes.
•Please ensure that this product is properly grounded.
•The installer should leave these instructions with the consumer who should retain for local inspector's use and
for future reference.
Make sure that incoming voltage is the same as unit rating. An electric rating plate specifying voltage,
hertz, wattage, amps, and phase is attached to the product. Wiring the dishwasher with more voltage than
it is rated for may cause severe damage to the thermistor, element, and other components. Wiring the
dishwasher with less voltage than it is rated for may cause significant decrease in performance. To reduce
the risk of fire, electric shock, or injury to persons, installation work and electrical wiring must be done by
qualified people in accordance with all applicable codes and standards, including fire-rated conditions.
Electrical power must be turned off at circuit breaker or fuse box before connecting any electrical cables.
SEQUENCE OF DISHWASHER INSTALLATION
1. Prepare the location
2. Prepare the water supply
3. Prepare the drain
4. Prepare the electrical supply
5. Adjust the feet
6. Push the dishwasher into place
7. Connect water supply
8. Connect drain supply
9. Connect electricity
10. Fasten the dishwasher
11. Install the kickplate
12. Install the door
INTRODUCTION
Read these instructions carefully and completely before installing the dishwasher. The installation should be carried out
by a qualified person, who is familiar with all local codes and ordinances for electrical and plumbing connections. If the
dishwasher is being installed for the first time, most of the work has to be done before you move it into place. If you
are replacing an old dishwasher, you must check the old connections.
NOTE: The drain hose is fastened to the back of the machine at the best high loop height.
To eliminate potential drain problems, leave this hose in place.
WARNING!
WARNING!
2

TOOLS YOU WILL NEED

1) Phillips No. 2 screwdriver
2) Flat blade screwdriver
3) Torx screwdriver size T 20
4) Adjustable wrenches
(if copper fittings are used)
5) Open ended wrenches
1/2" (1.3 cm) or 5/8" (1.6 cm)
6) Wire cutters and strippers
7) Tape measure
8) Level
9) Electric Drill
10) 1" drill bit or hole saw

MATERIALS YOU WILL NEED

FOR INSTALLATION:
-Min. 3/8" (.95 cm) OD copper tubing of sufficient length for your installation
-Shut-off valve and fittings for water supply line
1)
2)
3)
4)
5)
6)
7)
8)
9)
10)
3