Lennox Crestline LSBV-3628MN Care And Operation Instructions Manual page 11

LENNOX HEARTH PRODUCTS • CRESTLINE™ SERIES B-VENT GAS FIREPLACES • 36"/42" LSBV MODELS • CARE AND OPERATION INSTRUCTIONS
Proper log placement is critical to prevent soot-
ing. Carefully position the ceramic fiber logs
over the burner as described in the following
steps, and detailed in Figures 7 through 12.
Note: Logs should be placed in the gaps between
the flame peaks and should be positioned so
that at no time they impinge the flames.
The logs are packaged within the firebox. The
Volcanic Stone (2 bags) and Glowing Embers
(rockwool) (1 bag) are in the bottom of the
burner tray.
Spread 1-1/2 bags of Volcanic Stone evenly
inside of the burner tray, as shown in Figure 7.
The rest of the 1/2 bag of Volcanic Stone should
be used only on LSBV-42 models, placed on
the open spaces on the bottom of the firebox
between the refractory and burner tray.
Rear Log Pin
Rear Log Pin
Vertical Brackets
Volcanic Stone
Figure 7
These appliances are equipped with a beautifully
crafted six (6) piece ceramic fiber log set. The
logs, shown in Figure 13 on Page 12, are to be
positioned precisely as shown. Any modifica-
tion to the lay of the logs may result in sooting,
property damage and injury or death.
The rear log has mating holes for pin engage-
ment on its bottom side. DO NOT force a hole
into a log by engaging the pins where they are
not intended to go.
Apparent minor misalignment of the pins and
holes or landings can be eliminated by gently
adjusting the position of the logs until the pins,
holes or landings easily mate.
Step 1. To position the logs, begin by placing
the rear log in position over the two pins located
at the left rear and right rear of the log grate,
see Figure 7 and Figure 8.
Figure 8
Step 2. Position the bottom log, (see Figure 7
and Figure 9) between the two vertical brackets
of the burner tray.
Remove the Glowing Embers from the plas-
tic bag and tear into quarter size pieces, as
shown in Figure 9. Spread across the front
part of the burner. Do Not use more than is
necessary to cover the burner. When properly
positioned, the Glowing Embers will unevenly
cover approximately 85% of the burner with no
appreciable gaps.
Bottom Log
glowing Embers
Figure 9
Step 3. Place the left log as shown in Figure
10, on the landing of the rear log. Make sure
the landing on the front end of the log is resting
on the first left finger of the grate, as shown
in Figure 10.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Rear Log
Left Log
Figure 10
Step 4. Position the center log as shown in
Figure 11, with the two branches sitting on the
two landings provided on the top of the left log.
The other end of the center log has a groove
that should fit against the second right finger
of the grate, as shown in Figure 11.
Left Log Landings
Center Log
Figure 11
Step 5. Place the right log as shown in Figure
12, with the upper end sitting on the landing
provided on the rear log. Another end of the
Log grate
right log should rest on the first right finger
of the grate (see Figure 12). Position the top
right log as shown, locating it on the landing
of the center log.
Center Log Landing
Figure 12
Rear Log Landing
Left grate Finger
Second Right grate Finger
Top Right Log Right Log
Right grate Finger
11