Controls - Cub Cadet 2X 728 TDE Operator's Manual

Controls and Features
Chute Assembly
Chute Clean
Out Tool
WARNING!
instructions and warnings on the machine and in
this manual before operating.
Shift Lever
The shift lever is located in the right side of the handle panel and
is used to determine both the ground speed and direction of
travel. It can be moved into any of eight positions.
Forward
Your snow thrower has six forward (F) speeds, with position
number one (1) being the slowest.
Reverse
Your snow thrower has two reverse (R) speeds, with position
number one (1) being the slowest.
NOTE: Always release the drive control before changing speeds.
12
Track Lock Lever
Drive Control
Shift Lever
Headlight
Augers
Read, understand, and follow all
Chute Directional
Control
Skid Shoe
Figure 4-1
Headlight
The headlight is on whenever the engine is running.
Heated Grip
CAUTION:
gloves when using the heated grip. If the heated
grip becomes too hot, turn it off.
To activate the heated grips, move the switch found on the rear
of the dash panel into the ON position.
To turn off the heated grips, move the switch found on the rear
of the dash panel to the OFF position.
Auger Control
Heated Grips
Steering Trigger
Control
It is recommended that you wear
ON OFF
4