Deluxe; Remote Deflector Control Adjustment; Discharge Chute - Ariens Deluxe 28 Manual

REMOTE DEFLECTOR
CONTROL ADJUSTMENT
(Figure 29)
Deflector must stay in selected position while
throwing snow.
If deflector does not stay in set position:
1. Tighten nut beneath control panel to
increase pressure on deflector control
(Figure 29).
3
1
1. Cable Adjusting Nuts
2. Cable Support Bracket
3. Control Lever Nut
Figure 29
If deflector does not follow full range of travel:
1. Push deflector remote all the way
forward.
2. Loosen adjusting nuts on cable support
bracket underneath the control panel
(Figure 29).
3. To adjust the deflector lower:
Slide cable down. Tighten bottom nut.
4. To adjust deflector higher:
Slide cable up. Tighten top nut.
5. Check travel and repeat adjustment as
necessary.
2
EN - 28

DISCHARGE CHUTE

(921028, 029)
(Figure 30)
If chute does not stay in position while
throwing snow or if chute does not rotate
freely, adjust the cable under the gear cover
so the chute lock fingers engage or
disengage the locking gear.
If chute does not stay in position:
Loosen the cable by loosening the rear
adjustment nut, and then tightening the
forward adjustment nut against the bracket
until the lock arm engages the gear teeth.
1. Forward
If chute does not rotate freely:
Tighten the cable by loosening the forward
adjustment nut, and then tightening the rear
adjustment nut against the bracket until all
cable slack is removed and lock arm engages
teeth (Figure 30).
DISCHARGE CHUTE CONTROL
(921023, 024, 030, 032, 035)
(Figure 31)
If discharge chute does not stay in position
while operating, tighten nut on carriage bolt at
pivot point to increase tension on spring.
1
2
1. Spring
2. Nut
Adjustment Nut
2. Rear
Adjustment Nut
Figure 30
Figure 31