Installing The E-Mu 1010 Pci Card - E-Mu 1212m Owner's Manual

Installing the E-MU 1010 PCI Card

This installation is very simple but if you are not familiar with the installation of
computer peripherals and add-in boards, please contact your authorized E-MU
Systems dealer or an approved computer service center to arrange for the installation.
To install the 1010 PCI card into your computer
Make sure that the power switch on your computer is off.
1.
IMPORTANT: Unplug the power cord from the wall outlet!
Touch a metal plate on your computer to ground yourself and to discharge any
2.
static electricity.
Follow the computer manufacturer's recommended procedure for opening the
3.
case.
Remove the metal bracket from one PCI slot. If you have the E-MU 1212M system
4.
or the Sync Daughter Card you'll need to remove the bracket from two PCI slots.
Put the screw(s) aside for use later. See figure 1 below.
Figure 1
Align the E-MU 1010 PCI card with the slot and press gently but firmly down into
5.
the slot as shown in figure 2.
Do not force the E-MU 1010 card into the slot. Make sure that the gold finger
6.
connector of the card is aligned with the PCI bus connector on the motherboard
before you insert the card into the PCI slot. If it doesn't fit properly, gently remove
it and try again.
Secure the card into the slot using one of the screws you placed aside earlier.
7.
E-MU PCI Digital Audio Systems
Figure 2
2 - Installation
Installing the E-MU 1010 PCI Card
Note: Some
computer cases don't use
screws to secure PCI cards.
In this case, follow the
instructions that came
with your computer.
15