Zanussi ZKN7147J User Manual page 27

Unscrew the three
bolts.
Open the porthole,
remove the polystyr-
ene block fitted on
the door seal and pull
out all items from the
drum.
Positioning
Install the machine on a flat hard floor. Make
sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that
the machine does not touch the wall or other
kitchen units. Level the washing machine by
raising or lowering the feet. The feet may be
tight to adjust as they incorporate a self locking
nut, but the machine MUST be level and stable.
Any necessary adjustment can be made with a
spanner.
Accurate levelling prevents vibration, noise and
displacement of the machine during operation.
Never place cardboard, wood or similar materi-
als under the machine to compensate for any
unevenness in the floor.
www.zanussi.com
Slide out the relevant
plastic spacers.
Fill the smaller upper
hole and the two
large ones with the
corresponding plastic
plug caps supplied in
the bag containing
the instruction book-
let.
Water inlet
The inlet hose is supplied with the appliance
and it can been found inside the machine drum.
Warning! This appliance must be
connected to a cold water supply.
Caution! Before connecting up the
appliance to new pipework or to pipework
that has not been used for some time, run off a
reasonable amount of water to flush out any
debris that may have collected.
Caution! Do not use the hose from your
previous appliance to connect to water
supply.
35°
If necessary, check
the setting with a spi-
rit level.
1. Connect the ap-
propriate end of
the hose to a tap
with a 3/4"
thread. Always
use the hose
supplied with the
appliance.
45°
27