Troubleshooting - HoMedics WFL-REON Instruction Manual And Warranty

TROUBLESHOOTING

• If the pump fails to operate, check the following:
Check the circuit breaker, or try a different outlet to make sure the pump
is getting electrical power. NOTE: always disconnect from electrical outlet
before handling the pump.
Check the pump discharge and tubing for kinks and obstructions. algae
build-up can be flushed out.
remove the pump inlet to access the impeller area. turn the rotor to
ensure it is not broken or jammed.
NOTE:
monthly maintenance will add to your pump's life.
• If the pump gurgles, spews, or "burps":
Check the water level to make sure the pump has enough water to function.
• Obtaining a desired water level:
Check the water level daily the first week to measure the rate of evapora-
tion; refill with water as needed.
NOTE:
it is recommended the pump be set at its highest speed and later
adjusted to a lower setting if desired. Be sure to unplug the pump before
adjusting the speed setting.
8
Attention: Fig. 7
In order to get best
results, please
operate pump com-
pletely submerged.
Keep the water
level above the
minimum water
level ALL THE TIME.
READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
minimum Water level
Flow Control lever
(+) faster water output
(–) slower water output
9