HoMedics WFL-OLBR Instruction Manual And Warranty page 3

ASSEMBLY INSTRUCTIONS:
Item includes: Fig. 1
A-Base
B-Pump
C-Fountain Top
D-Platform
E-Switch
F-Adaptor
G-Branch
1. unpack the product. Be sure that all parts listed are included.
2. Familiarize yourself with the water pump. the WatEr pump speed
is controlled by the switch located at the front of the WatEr pump.
the speed is indicated by a plus (+) and minus (-) sign. to increase
the speed, move the switch slowly in the direction of the plus sign.
at its highest speed level, the switch will not move any further. to
decrease the WatEr pump speed, move the switch toward the
minus sign. Similarly, at its lowest speed, the switch will not move
any further.
Note: it is recommended the WatEr pump be set as its highest
speed during assembly and later adjusted to a lower setting if
desired. Be sure to unplug the WatEr pump before adjusting the
speed setting.
3. place the base on a flat surface, and lead the pump cord through
the cord slot on the bottom of the base (Fig 2). this will ensure that
the unit is balanced when placed on a flat surface.
4. insure the branch seats into the notch at the platform of the fountain
top (Fig.3).
5. insert the pump outlet into the water tube, so that the fountain top
stands on the base securely.
6. Fill the base with clean water up to the level of the platform surface
(Fig 4).
7. plug the cord into 120V household outlet. the fountain is controlled
by the switch located on the power cord. if pump doesn't operate,
rotate in-line switch once to turn on and once more to turn off.
Note: Ensure that the electrical cord loops below the electrical outlet
to form a "drip loop". this will prevent water from running down the
cord into the electrical outlet (Fig 5).
For best results, keep the pump completely submerged at all times.
4
Fig. 1
Clean Water
a. Base
B. pump
notE:
the diagrams shown are for illustrative purposes only.
Fig. 2
Flat Surface
Base
Branch
Switch
C. Fountain top
G. Branch
d. platform
E. Switch
F. adaptor
Fig. 3
5
Branch