Configuration Summary (Telecommuter Example - NETGEAR DG834Gv5 User Manual

6. Test the VPN tunnel by pinging the remote network from a PC attached to the DG834G v5.
a. Open the command prompt (Start -> Run -> cmd)
b. Type ping 172.23.9.1
Figure B-12
Note: The pings might fail the first time. If this happens, try the pings a second

Configuration Summary (Telecommuter Example)

The configuration in this section follows the addressing and configuration mechanics defined by
the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Assure that there are no firewall restrictions.
Table B-3. Configuration Summary (Telecommuter Example)
VPN Consortium Scenario:
Type of VPN:
Security Scheme:
IP Addressing:
Gateway
Client
NETGEAR VPN Configuration
Wireless ADSL2+ Modem Router DG834Gv5 User Manual
time.
Scenario 1
PC/client-to-gateway, with client behind NAT router
IKE with Pre-shared Secret/Key (not certificate-based)
Fully Qualified Domain Name (FQDN)
Dynamic
v1.0, March 2010
B-11