AEG FAVORIT 55030 User Manual page 19

WARNING!
Deactivate the appliance before you do the checks.
Malfunction
The appliance
does not fill with
water.
The appliance
does not drain the
water.
The anti-flood de-
vice is on.
The start of the
washing pro-
gramme does not
occur.
After the check, set the programme knob on the same washing programme before the
malfunction occurred. The programme continues from the point of interruption.
If the malfunction occurs again, contact the service centre.
If the display shows other alarm codes, contact the service centre.
The necessary information for the service centre is on the rating plate.
Record this information:
Possible cause
The water tap is blocked or there is
limescale on it.
The water pressure is too low.
The water tap is closed.
The filter in the water inlet hose is
blocked.
The connection of the water inlet
hose is not correct.
The water inlet hose is damaged.
There is a blockage in the sink spi-
got.
The connection of the water drain
hose is not correct.
The water drain hose is damaged.
The appliance door is open.
You did not press the Start touch-
pad or button.
The mains plug is not connected in
the mains socket.
The fuse in the fuse box is dam-
aged.
The delay start is set.
What to do if...
Possible solution
Clean the water tap.
Contact your local water authority.
Open the water tap.
Clean the filter.
Make sure that the connection is cor-
rect.
Make sure that the water inlet hose
has no damages.
Clean the sink spigot.
Make sure that the connection is cor-
rect.
Make sure that the water drain hose
has no damages.
Close the water tap and contact the
service centre.
Close the appliance door.
Press the Start touchpad or button.
Connect the mains plug.
Replace the fuse.
• Cancel the delay start.
• When the countdown is comple-
ted, the washing programme starts
automatically.
19