Test-Scanning Documents - Fujitsu fi-6110 Getting Started Manual

3.
Connect the AC cable with the AC adapter
(hereinafter referred to as "the power
cable").
WARNING
Be sure to use the supplied power cable.
The following cases may cause electrical
shock or malfunction.
Using a power cable other than that
supplied
Using the supplied power cable for other
devices
4.
Connect the power cable to the power
connector of your scanner and to the AC
outlet.
When you plug the AC cable into an
outlet, the [Power] button of the
operator panel on the scanner will
flash once. Note that this is an initial
diagnosis and not a malfunction.

Test-Scanning Documents

Using ScandAll PRO, you can test-scan
documents to check if they are scanned correctly.
For details about scanning documents by using
PaperStream Capture and the PaperStream IP
driver, refer to the help of each software.
The following describes how to test-scan a
document:
1.
Press the [Power] button on the operator
panel of the scanner.
The power is turned on, and the [Power]
button lights in green.
During initialization, the Function Number
Display of the operator panel changes as
follows: "8"
scanner is ready when "1" is displayed.
If "1" is not shown in the Function
Number Display, refer to "Chapter 8
Troubleshooting" in the Operator's
Guide.
When you press the [Power] button,
the Check LED will flash once. Note
that this is an initial diagnosis and not
a malfunction.
2.
Turn on your computer.
The scanner is automatically detected.
When the [Found New Hardware]
dialog box appears, select [Locate and
install driver software
(recommended)], and install the driver
by following the on-screen
instructions.
3.
Load a sheet into the scanner.
1. Pull out the chute extension 1 and chute
extension 2 according to the length of the
sheet.
2. Load the document in the ADF paper chute.
Set the sheet with its front side (scanning
side) facing the ADF paper chute.
7
Check LED
Check
Function
Function
Number
Send to
Scan Display
/Stop
Power
[Power] Button
"P" "0" "1". The