Hitachi ic35l060avv207-0 - Deskstar 60 GB Hard Drive Specifications page 210

Status Flag definitions
Bit Definition
Pre-failure/advisory bit
0
An attribute value less than or equal to its corresponding attribute threshold indicates an
0
advisory condition where the usage or age of the device has exceeded its intended
design life period.
An attribute value less than or equal to its corresponding attribute threshold indicates a
1
pre-Failure condition where imminent loss of data is being predicted.
On-line Collective bit
1
The attribute value is updated only during Off-line testing.
0
The attribute value is updated during On-line testing or during both On-line and Off-line
1
testing.
Vendor specific
2 - 5
6 - 15 Reserved (0)
Normalized values
The device performs conversion of the raw attribute values to transform them into normalized values,
which the host can then compare with the threshold values. A threshold is the excursion limit for a
normalized attribute value.
11.42.2.3 Off-line Data Collection Status
The value of this byte defines the current status of the off-line activities of the device. Bit 7 indicates Auto-
matic Off-line Data Collection Status.
Bit 7 Automatic Off-line Data Collection Status
Automatic Off-line Data Collection is enabled
1
Automatic Off-line Data Collection is disabled
0
Bits 0 thru 6 represents a hexadecimal status value reported by the device.
Value Definition
Off-line data collection never started
0
All segments completed without errors
2
Off-line data collecting suspended by interrupting command
4
Off-line data collecting aborted by interrupting command
5
Off-line data collection aborted with fatal error
6
11.42.2.4 Self-test execution status
Bit Definition
Percent Self-test remaining. An approximate percentage of the self-test routine remain-
0-3
ing until completion; given in ten percent increments. Valid values are 0 through 9
Current Self-test execution status
4-7
0
1
2
3
4
5
6
7
15
The self-test routine completed without error or has not been run
The self-test routine aborted by the host
The self-test routine interrupted by the host with a hard or soft reset
The device was unable to complete the self-test routine due to a fatal error or to
unknown test error
The self-test routine completed with unknown element failure
The self-test routine completed with electrical element failure
The self-test routine completed with servo element failure
The self-test routine completed with read element failure
The self-test routine in progress
Deskstar 180GXP hard disk drive specifications
196