If the device in Address Offset mode receives this command with the nonvolatile option, the device
returns aborted error to the host.
The device returns the command aborted for a second non-volatile Set Max Address Ext command until
next power on or hardware reset.
Output Parameters To The Device
B
Sector Number Current
Sector Number Previous
Cylinder Low Current
Cylinder Low Previous
Cylinder High Current
Cylinder High Previous
Input Parameters From The Device
Sector Number (HOB=0)
Sector Number (HOB=1)
Cylinder Low (HOB=0)
Cylinder Low (HOB=1)
Cylinder High (HOB=0)
Cylinder High (HOB=1)
Option bit for selection whether nonvolatile or volatile. B=0 is volatile
condition. When B=1, MAX Address which is set by Set Max Address
Ext command is preserved by POR. When B=0, MAX Address which is
set by Set Max Address Ext command will be lost by POR. B=1 is not
valid when the device is in Address Offset mode.
Set Max LBA (7:0).
Set Max LBA (31:24).
Set Max LBA (15:8).
Set Max LBA (39:32).
Set Max LBA (23:16).
Set Max LBA (47:40).
Set Max LBA (7:0).
Set Max LBA (31:24).
Set Max LBA (15:8).
Set Max LBA (39:32).
Set Max LBA (23:16).
Set Max LBA (47:40).
Deskstar 180GXP hard disk drive specifications
186