WeiderPro Pro 435 Bench User Manual page 7

2. Orient the Crossbar (3) as shown. Attach the
Crossbar to the left Upright Base (7) with four
M10 x 80mm Bolts (35), two Joint Plates (20),
and four M10 Nylon Locknuts (19). Do not tight-
en the Nylon Locknuts yet. Note: If the Upright
(not shown) has been preassembled, lift it out
of the way of the bolts going through the
Upright Base.
Attach the Crossbar (3) to the right Upright Base
(not shown) in the same manner.
3. Press a 50mm Square Inner Cap (54) halfway
into the top of the Front Leg. Press two 40mm x
50mm Inner Caps (68) into the Stabiliser (66).
Orient the Stabiliser (66) with the indents around
the holes on the bottom. Attach the Stabiliser to
the Front Leg (8) with two M10 x 52mm Carriage
Bolts (64) and two M10 Nylon Locknuts (19). Do
not tighten the Nylon Locknuts yet.
Attach the Front Leg (8) to the Bench Frame (2)
with two M10 x 70mm Bolts (18), the Support
Plate (14), and two M10 Nylon Locknuts (19). Do
not tighten the Nylon Locknuts yet.
4. Lubricate an M10 x 75mm Bolt (51). Attach the
Bench Frame (2) to the upper set of holes in the
bracket on the Crossbar (3) with the Bolt, two
M10 Washers (24), and an M10 Nylon Locknut
(19). Do not overtighten the Nylon Locknut;
the Bench Frame must be able to pivot easily.
Insert the Ring Pin (43) into the lower set of holes
in the bracket on the Crossbar (3). Tighten the
M10 x 57mm Adjustment Knob (33) into the
Crossbar and Bench Frame (2).
Tighten all of the M10 Nylon Locknuts (19)
used in steps 1–3.
5. Press three 45mm Square Inner Caps (21) into
the Leg Lever (4).
Slide the Weight Tube (41) through the Leg Lever
(4) and secure it with an M8 x 57mm Bolt (39),
two M8 Washers (38), a Small Spacer (37), and
an M8 Nylon Locknut (13).
Press a 25.4mm Round Inner Cap (23) into the
indicated end of the Weight Tube (41). Press the
25.4mm Angled Cap (29) onto the other end of
the Weight Tube.
2
3
35
3
54
14
19
19
68
Indents
64
4
Lubricate
51
2
5
4
21
39
38
41
23
7
19
20
7
19
20
18
2
18
8
19
66
68
33
Bracket
19
3
24
43
21
37
29
13
38
21