Weider Pro 325 User Manual page 9

14. See the inset drawing. Press two Carriage
Bushings (52) into the top and bottom of the
Weight Carriage (50). Press two 25mm Round
Inner Caps (23) into the ends of the weight tube
on the Carriage. Insert the M10 x 19mm Bolt (60)
into the bracket on the Carriage from the side
shown.
See the inset drawing. Press the Carriage Stop
Bushing (72) into the Weight Stop (53).
Press two 60mm Square Inner Caps (22) into the
ends of the Rear Upright (49).
Slide the Weight Carriage (50) onto the Rear
Upright (49), as shown. Slide the Weight Stop
(53) onto the Rear Upright and secure it with an
M10 x 86mm Bolt (59) and an M10 Nylon Locknut
(11).
15. Attach the Rear Upright (49) to the Frame (43)
with four M10 x 78mm Bolts (67), a Support Plate
(61), and four M10 Nylon Locknuts (11). Do not
tighten the Locknuts yet.
14
22
52
23
50
60
52
72
53
15
43
67
9
49
50
23
11
59
22
49
11
61