General Operation; Mains On/Off; Standby; Auto Shut Off - Sanyo CE28WN5-B Instruction Manual

Mains ON/OFF

To turn the TV set ON, press the Mains ON/OFF switch. The
power indicator illuminates to show the power is on.
If no picture appears but the power indicator is on, press the
button, P , P or 0-9 button as the TV set is in the Standby
mode.
To turn the TV set OFF, press it again.

Standby

To turn the TV set into standby mode, press the
The power indicator illuminates more brightly.
To turn the TV set ON from standby mode, press any of the
following buttons: , P , P
In the Standby mode the TV set is still partially powered, this is
denoted by the red Standby/Power indicator illuminating more
brightly than in Power mode.
The Mains ON/OFF switch must be in the ON position before the
using remote control transmitter.
NOTE: It is not possible to turn on with the Mains ON/OFF
switch from the standby mode.
Be sure to set the Mains ON/OFF switch to the off
!
position, if a power failure occurs while viewing.
If you find the power indicator flashing, please turn the
!
TV set off completely with the Mains ON/OFF switch
and contact our Service desk. This warning is a sign to
let you know that the power protection function of this TV
set is now operating.
GENERAL OPERA
GENERAL OPERA
button.
or 0-9 buttons.
TION
TION

Auto Shut Off

This TV set will automatically switch into the standby mode, 10
minutes after a signal is no longer received. The time until the
set will switch off is displayed on the screen.
OFF 0:10
If the aerial is removed the TV set will automatically switch into
the standby mode after 10 minutes.
When the TV set is switched on by using the On-timer function
with no signal being received, the auto-shut off function will be
ignored.

Programme Selection

Direct Programme Selection
For selection of programme position 0 to 9, press the corresponding
numeric button. If the required programme is equal or more than
10, for example 23, first press the -/- - button and enter 2 then 3.
Up/Down Programme Selection
Press the P button to increase the programme position.
Press the P button to decrease the programme position.
99
0
1
2
3
7