Aerial Connection; Battery Installation; Mains Supply - Sanyo CE28WN5-B Instruction Manual

Aerial Connection

Insert an aerial plug tightly into the aerial socket on the back
of the TV set.
For all aerial problems please consult your local dealer.
The connection to the peripheral AV equipment, refer to section
"CONNECTION OF AV EQUIPMENT" on pages 12 & 13.
ANT.75
R/D

Battery Installation

1. Remove the battery cover by sliding it in direction of the arrow.
2. Install two "AA" 1.5 volt batteries so that the "+" and "-" marks
on the batteries match the "+" and "-" marks inside the unit.
3. Close the battery cover.
NOTE: Replace the batteries when the TV set is showing the
following symptoms: Operation is unsteady or erratic, sometimes
the TV does not work with the transmitter. Discharged batteries
may leak and damage the unit. The normal life of batteries
should be from nine to ten months.
4
INST ALLA TION
INST ALLA TION
The TV set is prepared for a mains voltage AC220~240V, 50Hz.
Connect the power cord of the TV set to a wall outlet. When the
TV set is not to be used for an extended period of time, it is
advisable to disconnect the power cord from the power outlet.
WARNING!
High voltages are used in the operation of this set. Refer service
to qualified service personnel.
Important:
This equipment is fitted with an approved non rewireable UK
mains plug. To change a fuse in this type of plug proceed as
follows:
1. Remove the fuse cover and fuse.
2. Fit a new fuse which should be a BS1362 5Amp A.S.T.A. or
BSI approved type.
3. Ensure that the fuse cover is correctly refitted.
If the fuse cover is lost or damaged the plug must NOT be used but
replaced with a serviceable plug.
If the fitted plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place. If the mains plug
contains a fuse, this should have a rating of 5 Amp, ensure the fuse
cover is correctly fitted. If a plug without a fuse is used, the fuse at
the distribution board should not be greater than 5 Amp.
Note: The severed plug must be destroyed to avoid a
possible shock hazard should it be inserted into a 13Amp
socket elsewhere.
The wires in this mains lead are coloured in accordance with
the following code:
Blue -------> Neutral
Brown ----> Live
1. The Blue wire must be connected to the terminal which
is marked with the letter "N" or coloured BLACK.
2. The Brown wire must be connected to the terminal with
the letter "L" or coloured RED.
3. Do not connect either wire to the earth terminal in the
plug which is marked with the letter "E" or by the earth
symbol or coloured GREEN or GREEN and YELLOW.
Before replacing the plug cover, make certain that the cord
grip is clamped over the sheath of the lead - not simply over
the wires.

Mains Supply