Ice Corner Door Replacement; Icemaker Assembly; Auger Motor Cover - Kenmore 795.71022.010 Service Manual

3-14 ICE CORNER DOOR REPLACEMENT

1) Loosen the front screw as shown in the picture.
2) Lift up the hinge with one hand.
3) Pull out the Ice Corner Door with the other hand.

3-15 ICEMAKER ASSEMBLY

1) Loosen two screws as shown in the first picture.
2) Disconnect the wire harness & ground screw replace
theIcemaker assembly in the reverse order of removal.
3) It separates a ground connection screw.

3-16 AUGER MOTOR COVER

1) After removing the icemaker remove the (5) stainless
screws holding the auger motor cover, shown in the
picutres below.
2) Grip the bottom of motor cover assembly and pull out it.
3) Disconnect wire harness of motor cover assembly.
There is a auger motor on the back, as shown in the
picture.
- 12 -
Auger Motor