Changing The Wide Screen Mode; Operating The Picture Adjustment - Pioneer AVIC-X1 Hardware Manual

MAN-AVIC-X1-EN HW.book Page 16 Friday, January 16, 2004 11:41 AM

Changing the wide screen mode

• Press WIDE button to select the desired
setting.
Press WIDE button repeatedly to switch
between the following settings:
FULL (full) – JUST (just) – CINEMA
(cinema) – ZOOM (zoom) – NORMAL
(normal)
FULL (full)
A 4:3 picture is enlarged in the horizontal
direction only, enabling you to enjoy a 4:3 TV
picture (normal picture) without any omissions.
JUST (just)
The picture is enlarged slightly at the centre and
the amount of enlargement increases
horizontally toward the ends of the picture,
enabling you to enjoy a 4:3 picture without
sensing any disparity even on a wide screen.
CINEMA (cinema)
A picture is enlarged by the same proportion as
FULL or ZOOM in the horizontal direction and
by an intermediate proportion between FULL and
ZOOM in the vertical direction; ideal for a
cinema-sized picture (wide screen picture) where
captions lie outside.
ZOOM (zoom)
A 4:3 picture is enlarged in the same proportion
both vertically and horizontally; ideal for a
cinema-sized picture (wide screen picture).
NORMAL (normal)
A 4:3 picture is displayed as it is, giving you no
sense of disparity since its proportions are the
same as that of the normal picture.
Different settings can be memorised for each
video source.
When video is viewed in a wide screen mode
that does not match its original aspect ratio, it
may appear differently.
Remember that use of this system for
commercial or public viewing purposes may
constitute an infringement on the author's
rights protected by the Copyright Law.
Video will appear grainy when viewed in
CINEMA or ZOOM mode.
16
The navigation map and the rear view camera
picture is always FULL.
Operating the picture
adjustment
1
Press WIDE button and hold to display
PICTURE ADJUST.
BRIGHT – Adjust the black intensity
CONTRAST – Adjust the contrast
COLOR – Adjust the colour saturation
HUE – Adjust the tone of colour (red is
emphasised or green is emphasised)
DIMMER – Adjust the brightness of display
BACK-CAMERA – Switch to the picture
adjustment display for the rear view camera
Touching "SOURCE" (or "NAVI") while
adjusting the rear view camera image
returns you to the previous screen. (Except
when the vehicle's gearstick is in reverse
[R].)
The adjustments of BRIGHT and
CONTRAST are stored separately for
light ambient (daytime) and dark ambient
(nighttime). A sun
displayed to the left of BRIGHT and
CONTRAST, respectively, as the ambient
light sensor determines brightness or
darkness.
You cannot adjust HUE for PAL video.
You cannot adjust COLOR and HUE for
the source without a video and navigation
map display.
You can adjust the picture adjustment for
the rear view camera only when CAMERA
in SETUP menu is turned on.
Setting for rear view camera
Manual
The picture adjustment may not be able to
be used with some rear view cameras.
The same setting is selected for the normal
background picture and the navigation
map display.
2
Touch "+" or "–" to adjust the selected
item.
Each time you touch "+" or "–" increases or
decreases the level of selected item.
+24 – –24 is displayed as the level is
increased or decreased.
or moon is
Operation